C2 Redline 6 Gauge Set, Stainless Bezels, 240-33 Ohm Fuel Level Gauge on 2040-parts.com

• We double check each gauge for correct operation before packing your order.  This process includes putting signals to all gauges to verify correct operation.
• We verify no accessory items are missing (u-clamps, bulbs, senders etc) .
• We photo document your order to ensure completeness.
• Fast shipping via USPS Priority Mail service.
• "No hassle" extended warranty.  If you buy from us and have an issue with a gauge just send it back and we'll replace it, even it is more than 1 year later.  

Features:

• High quality gauges made in Orange County, CA USA.
• High-speed full sweep stepper motor speedometer and tachometer
• Speedometer in Miles per Hour and KM per Hour
• Short sweep electric 2-1/16" gauges 
• Fuel level gauge available in 5 different ranges (*see below for more info)
• Programmable speedo with one-step easy calibration and 2 Trip meters
• White through-the-dial LED lighting with stylish red accents for easy viewing at night
• 3D glowing pointer for easy visibility at night

Set includes:

• 3-3/8" Electric Programmable Speedometer, 0-160 MPH (0-240 KM per Hour)
• 3-3/8" Tachometer, 0-10,000 RPM
  
• 2-1/16" Volts, 8-18V  
• 2-1/16" Oil Pressure, 0-100 PSI with Sender
• 2-1/16" Water Temperature, 120-280F with Sender
• 2-1/16" Fuel Level Empty-Full, 240-33 Ohm input range (other ranges are available, see below for details).
  

Made in the U.S.A.
This item is made in California, USA.  Please allow 1-2 days for your item to be made before it ships.

Matching Vac/Boost, Trans Temp, Oil Temp & Fuel Pressure Gauges
Matching Vac/Boost, Transmission Temperature, Oil Temperature, and Fuel Pressure gauges are available for this gauge set.  Please contact us to order.

Frequently Asked Questions

Are sending units included?
The oil pressure and water temp sending units are included. 

The volts gauge does not require a sender. 

A fuel level sender is not included.  The fuel level gauge is a 240-33 ohm fuel level gauge that works with 240-33 ohm sending units.  We can also supply the following fuel level gauge ranges as special order:

• 73-10 ohm (Ford and MOPAR)
• 20-150 ohm (Most FORD vehicles after 1985)
• 0-30 ohm (Most GM Vehicles Before 1965)
• 0-90 ohm (Most GM Vehicles after 1965)

Speedometer will work with any OEM or aftermarket speed sensor or electronic module that meets the following conditions:

1. Pulse range generated proportional to the vehicle speed
2. Signal with minimum 3V peak to peak signal - typical for 3-wire hall effect and 2 wire vehicle speed sensor outputs
3. output of 4,000 to 200,000 pulses per mile (most senders are 16,000 ppm)

If you currently have a mechanical speedometer (cable driven) you will need a hall effect sender.  See the "Accessories" section of our eBay store add a hall effect sender to your order.  The hall effect sender installs on your current transmission cable take off location. The signal from the hall effect sender (12V Square Wave signal) drives the electric speedometer.

The tachometer does not require a sender - you get the signal from the coil (-) or other tach signal source (i.e. ECU or Tach output on HEI or ignition box).

TERMS & CONDITIONS
Standard terms and conditions apply to this item.  See our terms and conditions here: Terms & Conditions.