Find or Sell any Parts for Your Vehicle in USA

Sport Baby Ace D Aircraft Lsa 24x48" 4 Wing Prints Only Cr 85-120mph on 2040-parts.com

US $89.00
Location:

Prescott Valley, Arizona, United States

Prescott Valley, Arizona, United States
THESE ARE WING PLANS ONLY. Including BLUE PRINT SHEETS # 801, 802, 803 and sheet # 804. The sheet contents are described below.
Warranty:No Country/Region of Manufacture:United States Compatible Make:Corben Baby Ace

This auction is for a set of 4 prints for the WING COMPONENTS, ONLY of the BABY ACE MODEL D AIRCRAFT. They are in like new condition and have never been used. These plans were produced by E Emanuel (3/1958) and purchased about 7 years ago. They are stapled on one end, which helps to keep them aligned, in order and in good condition. I don't have the remaining sheets for the other parts of the airplane, as they were previously sold. These sheets were purchased as extra plans.

The complete list of blue prints included in this auction, are as follows:

Sheet # 801 is for the wing + Aileron + 2 Spars.
Sheet # 802 is for the Wing Hardware+ Spar, reinforcing plate, Aileron horn and Wing Bow..
Sheet # 803 is for the Wing Fittings + cable attachment details + a list of materials.
Sheet # 804 is for the left wing panel construction, hinges, horn, cables, pulleys and drag wires.


Baby Ace Model D
In 1956, Mr. Dzik once again helps to modify and re-engineer the Baby Ace Model C to create the Baby Ace Model D.  The Model D has a more modern design with contemporary tailfeathers.

Corben/Lambert Baby Ace D

Location: Homebuilts

The Baby Ace was built in the early 1960s by Stafford “Casey” Lambert at his summer home on Lake Minocqua in northern Wisconsin. Paul Poberezny, a longtime friend of Casey, assisted with the project and flew much of the time that was put on the little sport plane.

Casey made enough changes to the Baby Ace that a new model designation was felt justified. The fuselage at the cockpit was widened to materially increase comfort for the pilot. Where necessary, the fuselage was strengthened to accommodate floats and an 85 hp Continental engine. The ailerons were extended one foot inboard and the fin and rudder were enlarged. These include a few of the many changes made to the earlier Model C Baby Ace.

Initially, the airplane was mounted on floats that were manufactured in 1938, one of the only items that was not new when the Baby Ace was assembled. The 1938 floats were in near perfect condition and had no leaks despite their many years of service. However, they were later replaced with a set of new Edo 54-1140 floats, which are a marvel in lightweight but strong construction.

The name “Box Full”, the title Casey dubbed his latest creation, represents the 25th airplane he owned. As an ardent hunter-sportsman, Casey would explain that as 25 shotgun shells make a box full, so the Baby Ace fills his box of airplanes.

The Continental engine was later replaced with an oversized Lycoming O-290-D2, rated at 135 hp. The result was a floatplane that performed with the very best. Paul reported that the Baby Ace would take off the water in 350 feet and register 2500 feet per minute rate of climb. In addition, it would loop from level flight with Paul making as many as six consecutive loops without loss of altitude.

When Casey Lambert died, his estate donated the Baby Ace on floats to EAA. The “Box Full” Baby Ace has been on display in the AirVenture Museum ever since.

Span

26 ft.

Fuel Capacity

18 gal.

Engine

Continental C-85-12 at 85 hp

Floats

Edo 54-1140

Cruising Speed

100 mph

Stalling Speed

40 mph

Rate of Climb

900/1000 fpm

Net Weight

770 lbs.

Gross Weight

1170 lbs.


STANDARD DATA: Gross wt. 950. Empty wt. 575. Fuel capacity 17. Wingspan 26'5". Length 17'9". 
PERFORMANCE: Top mph 110. Cruise mph 100. Stall mph 34. Climb rate 1,200. Takeoff run 200. Landing roll 250. Range 350.

The Baby Ace is an ultralight monoplane specially designed for the amateur builder. It is the successor to the original Corben Baby Ace, which first flew in 1931 and was extensively redesigned in 1955 as the Model D. Baby Aces usually carry Continental engines rated from 65 to 85 hp, and owners consider their performance excellent. Construction consists of a steel-tube fuselage, all-wood wings, and fabric covering. Kits for model D and E are still offered.


Audi TT Coupe 1.8 TFSI launches as entry-level TT

Thu, 13 Oct 2011

The new entry-level Audi TT Coupe 1.8 TFSI We wonder if Audi is starting to feel a bit of pain from Peugeot’s RCZ? If it is, that would explain the decision to introduce a new entry-level Audi TT starting at just £24,070 – the  Audi TT Coupe 1.8 TFSI. The TT Coupe now gets the option of the entry-level engine already found in the TT Roadster, which means that once again you can get a TT Coupe for less than the entry-level TT Roadster.

Honda starts deliveries of FCX Clarity

Fri, 22 Aug 2008

By Ben Whitworth Motor Industry 22 August 2008 11:08 Honda has started first deliveries of its radical FCX Clarity fuel cell vehicle to customers in America. Some 200 hand-built FCX’s will be delivered to a wide range of customers, including high-profile celebrities – like actress Jamie Lee Curtis – as well as normal working families. The project is part of Honda’s goal to stimulate energy suppliers to create a more viable hydrogen supply network, a move backed by Arnold Schwarzenegger, the governor of California.

Awesome video of Porsche engine teardown

Tue, 09 Jul 2013

If you’re considering tearing down the 3.2-liter air-cooled flat-six in your 1984-1989 Porsche 911 , this stop-motion video should help motivate you. Skipping past all the stuck fasteners, broken parts and most of the unpleasant discoveries you’ll encounter when pulling any old engine apart has a way of making a full teardown seem downright manageable. But, whether you have an old 911 or not, this video is mighty entertaining and definitely worth a look.